IDS Software Suite 4.96.1
Digital output specifications
USB board revision |
1.2 |
2.0 or higher |
|
|---|---|---|---|
|
Max. |
Max. |
|
Output current (short-time) |
50 |
500 |
mA |
Output current (permanent) |
15 |
150 |
mA |
Output voltage |
30 |
30 |
V |
Breakdown voltage |
50 |
50 |
V |
Collector power dissipation |
100 |
125 |
mW |
|
For information on how to determine the USB board revision, please refer to the USB uEye SE driver compatibility chapter. |
The digital output is galvanically isolated using an optocoupler to protect the camera and the PC against surges. Only DC voltages may be applied to the digital output.
The output of the optocoupler can be used as an open collector or open emitter output. This means that the output signal can be connected to ground or to the supply voltage. The output signal is active if the collector-emitter switch is closed (software setting "Flash high active").
Digital output wiring
The following figures show examples of how the digital output is wired.
Fig. 547: Wiring of the digital output as an open collector output (rev. 2.0)
Fig. 548: Wiring of the digital output as an open emitter output (rev. 2.0)
Fig. 549: Wiring of the digital output as an open collector output (rev. 1.2)
Fig. 550: Wiring of the digital output as an open emitter output (rev. 1.2)
